Sound modes and surround parameters

Smode & Spara1 X7200_dts
Smode & Spara2 X7200_dts

Update (DTS:X)

Smode & Spara DTS X7200_dts

This item can be selected when a DTS:X signal that is compatible with the Dialog Control function is input.

This item cannot be selected when a DTS:X format with a sampling frequency of over 48 kHz is input.

You can select DTS:X or DTS Neural:X if updated to DTS:X.

DTS Neo:X is no longer supported once you update to DTS:X.

Upgrade (Auro-3D)

Smode & Spara Auro X7200_dts

∗1 - ∗3, ∗6 - ∗11 : Sound modes and surround parameterslink

This item can be selected when the Dolby Digital, Dolby Digital Plus, Dolby TrueHD or Dolby Atmos signal is played back.

This item can be selected when the Dolby Digital, Dolby Digital Plus, Dolby TrueHD, Dolby Atmos, DTS:X or DTS is played back.

This item can be selected when a Dolby Digital or DTS signal or DVD-Audio is played.

During playback in Pure Direct mode, the surround parameters are the same as in Direct mode.

This setting is available when “Subwoofer Mode” in the menu is set to “LFE+Main”. link

This item cannot be set when “Dynamic EQ” is set to “On”. link

This item cannot be set when Audyssey® Setup (Speaker Calibration) has not been performed.

This item cannot be set when “MultEQ® XT32” in the menu is set to “Off”. link

This item can be set when the input signal is analog, PCM 48 kHz or 44.1 kHz.

This can be set when the LFE signal is included in the input signal.

This can be set if the input signal does not contain an Auro-3D signal or if the input Auro-3D signal does not contain Front Height channels.

back to top