Listening to DIGITAL IN

Remote control unit illustration

Ope RC1214 Dig
Prepare for playback.

Check the connection Connecting a digital devicelink, then turn on this units.

Press OPTICAL IN1 or OPTICAL IN2 to switch the input source to “OPTICAL IN 1” or “OPTICAL IN 2”.
Play the component connected to this unit.
NOTE

Do not input non-PCM signals, such as Dolby Digital, and DTS. This causes noise and could damage the speakers.

“SIGNAL UNLOCK” is displayed when audio signals that are not supported by this unit are input, or the sampling frequency cannot be detected.

Specifications of supported audio formats

back to top