Registering (Pairing) and connecting a Bluetooth device
Check that the headphones are not connected to any Bluetooth device before pairing.
Turn on the Bluetooth function of your Bluetooth device.
For details, see the Owner’s Manual of the Bluetooth device that you want to connect.
When the headphones power is off, press and hold the control button for approximately 3 seconds.
The status indicator LED lights purple for approximately 1 second and then flashes red and blue alternately indicating that the headphones are in pairing registration mode.
If the status indicator LED does not light even when the control button is pressed, the rechargeable battery has no power remaining. Charge the battery.
Select “DENON AH-C160W” from the list of devices displayed on the screen of your Bluetooth device.
When registration (pairing) is complete and a Bluetooth connection is established, the status indicator LED on the headphones lights blue for approximately 5 seconds.
Playing back music on the Bluetooth device.
Music played back on the connected Bluetooth device is output from the headphones.
If the power is on, turn the power off before pairing.
The headphones pairing registration mode is canceled if pairing is not completed within 3 minutes. In this case, press and hold the control button for approximately 3 seconds to turn the power off, and then try pairing again.
If you are requested to enter a PIN code (pass key), enter “0000” (four zeros).