1: Connecting to the headphones for the first time
Check that the headphones are not connected to any Bluetooth device before pairing.
For details, see the Owner’s Manual of the Bluetooth device that you want to connect.



The Bluetooth LED lights and then blinks in approximately 1-second intervals as the headphones enter pairing mode.

The headphones turn on after pressing and holding the /
button for approximately 2 second. Continue pressing the button.
If the Bluetooth LED does not light even when the /
button is pressed, the rechargeable battery has no power remaining. Charge the battery. link
When pairing is completed and the Bluetooth connection is established, the Bluetooth LED lights for approximately 5 seconds.

Music played back on the connected Bluetooth device is output from the headphones.
If the power is on, press and hold the /
button for approximately 3 seconds to turn the power off before pairing.
The headphones pairing mode is canceled if pairing is not completed within 3 minutes. In this case, press and hold the /
button for approximately 3 seconds to turn the power off and then pair the devices again.
If you are requested to enter a PIN code (pass key), enter “0000” (four zeros).