Wi-Fi Setup

Connect to a wireless LAN (Wi-Fi) router.
The router can be connected in the following ways. Select the connection method to suit your home environment.

Scan Networks

Select the network you wish to connect to from the list of possible networks shown on the TV screen.

Select the network you wish to connect to from the list of wireless networks.

Select “Rescan” if the network cannot be found.

Enter your password and select “OK”.

Use iOS Device

Use your iOS device (iPhone/iPod/iPad) to connect to the network. By connecting your iOS device to this unit, the unit can be automatically connected to the same network as your device.

This unit can be connected to your iOS device in two ways, using a USB cable and using Wi-Fi.

When connecting using Wi-Fi

Select “Wireless connection” on the TV screen.
Check that your iOS device is connected to the wireless LAN (Wi-Fi) router and select “Denon AVR-X4100W” from “SET UP NEW AIRPLAY SPEAKER...” at the bottom of the Wi-Fi configuration screen of your iOS device.
Tap “Next” on the screen of the iOS device.

The iOS device firmware version needs to support iOS7 or later.

When using a USB cable

Select “USB cable” on the TV screen.
Check that your iOS device is connected to the wireless LAN (Wi-Fi) and connect it to the USB port on the front panel using a USB cable.
Select “Connect” on the TV screen.
Tap “Allow” when the connection message appears on the screen of your iOS device.

The iOS device firmware version needs to support iOS5 or later.

WPS Router

Use a WPS-compatible router to connect.

There are two ways to connect, using the push button method or the PIN code method. Select the connection method to match your router.

When connecting using the push button method

Select “Push Button” on the TV screen.
Switch to the WPS mode by pressing the WPS button of the router you wish to connect to.

The time for pressing the button varies depending on the router.

Select “Connect” on the TV screen within 2 minutes.

When connecting using the PIN code method

Select “PIN” on the TV screen.
Register the PIN code of the unit in the router.

Manual

Enter the name (SSID) and password of the network you wish to connect to.

Set the following items.

SSID:

Input the name of the wireless network (SSID).

Security:

Select the encryption method according to the encryption setting of the access point you are using.

Password:

Input the password.

Default Key:

Select the Default Key.

When connecting to a “WEP” encrypted network, “Default Key” menu is displayed.

Select “Connect” at the end of the setting.

The wireless LAN (Wi-Fi) settings of this unit can also be configured from a PC or tablet that supports wireless LAN connection.

When using a device that has a firmware version of iOS7 or later, When connecting using Wi-Filink in “Use iOS Device”.

Press and hold the DIMMER and STATUS buttons on the main unit for at least 3 seconds when the power of the unit is on.
Connect the wireless LAN of the PC or tablet used to “Denon AVR-X4100W” when the message “Connect your Wi-Fi device to Wi-Fi network called “Denon AVR-X4100W”” appears in the display.
Start up the browser and enter “192.168.1.16” in the URL.
Use the browser to enter the settings, select “Connect” and then exit the settings.

back to top