Registering preset codes

There are two methods for registering preset codes; the simple method for registering preset codes of Denon players, and the method for registering the preset numbers of other manufacturers’ devices.

Registering Denon players

Use the following simple method to register the preset codes of Denon Blu-ray Disc players, DVD players and CD players.

Registering Blu-ray Disc players

Press and hold down Blu-ray and OPTION until the DEV, TV and AVR indicators on the remote are flashing green, then release.

Registering DVD players

Press and hold down DVD and OPTION until the DEV, TV and AVR indicators on the remote are flashing green, then release.

Registering CD players

Press and hold down CD and OPTION until the DEV, TV and AVR indicators on the remote are flashing green, then release.

Registering multiple players at the same time

Press and hold down QUICK SELECT 1 – 4 and OPTION until the DEV, TV and AVR indicators on the remote are flashing green, then release.

Devices to be registered at the same time

Press and hold down the buttons

Blu-ray Disc player

DVD player

CD player

check_mark

check_mark

QUICK SELECT 1 and OPTION

check_mark

check_mark

QUICK SELECT 2 and OPTION

 

check_mark

check_mark

QUICK SELECT 3 and OPTION

check_mark

check_mark

check_mark

QUICK SELECT 4 and OPTION

NOTE

Depending on the model and year of manufacture of your device, some buttons may not operate. In this case, try “Registering by entering preset numbers” link.

Registering by entering preset numbers

The following table shows the device groups that can be registered for each of the input source select buttons. Check the preset number of the device you want to register beforehand in the “Remote Control Preset Codes” file.

Check the URL.

Button

Device groups that can be registered

RC_CBL_SAT

CBL/SAT group

RC_Blu-ray

VCR/PVR group, BD/DVD group

RC_GAME

CBL/SAT group, VCR/PVR group,
BD/DVD group, Audio group

RC_MEDIAPLAYER

CBL/SAT group

RC_DVD

VCR/PVR group, BD/DVD group

RC_AUX1

CBL/SAT group, VCR/PVR group, BD/DVD group, Audio group

RC_AUX2

CBL/SAT group, VCR/PVR group,
BD/DVD group, Audio group

RC_CD

Audio group

RC_TVAUDIO

TV group

Press and hold down the input source button that you want to register the preset code to and SETUP until the DEV, TV and AVR indicators are flashing green.
Enter the preset number (5 digits) listed for the device in the Preset Code Table using the number buttons (0 – 9) on the remote control.

Some manufacturers use more than one type of preset code. Preset codes to change the number and verify correct operation.

NOTE

Depending on the model and year of manufacture of your device, some buttons may not operate.

back to top