Search result
Dirac Live
Filters exported from the Dirac Live software can be set by selecting Audio - Dirac Live in the Setup Menu.
These settings are enabled after the filter is sent to the unit from the Dirac Live software.
Slot 1∗: |
The Dirac Live filter that was exported to Slot 1 will be used. |
Slot 2∗: |
The Dirac Live that was exported to Slot 2 will be used. |
Slot 3∗: |
The Dirac Live that was exported to Slot 3 will be used. |
Off: |
Dirac Live filter will not be used. |
Filter names created in Dirac Live Software will be displayed in the user interface.
You can store a maximum of 3 filters when using Dirac Live Software.
Only the slot to which the filter was exported can be selected.
In addition to acoustic filters that correct frequency and time responses, Dirac Live also stores the output level and distance of each speaker for each filter.
The Dirac Live filter settings are stored for each input source.
When the sound mode is “Direct” or “Pure Direct”, only Distances and Levels will be applied. The acoustic filter will not be applied
Dirac Live is automatically turned off when headphones are used.
Graphic EQ cannot be set when Dirac Live is being used.
You can also set filters in Option Menu - Dirac Live.
An option menu screen is displayed.
When the input source is “HEOS Music”, an option menu for online music is displayed. Select “AVR Options…”, then press ENTER.
The “Dirac Live” screen is displayed.
Dirac Live setting data will be deleted when the speaker configuration is changed in “Speaker Layout” in the menu after performing Dirac Live Room Calibration. The measurement must be performed again if the speaker configuration has changed.
If the Dirac Live® filter option is applied to the filter you have set, you do not need to measure “Distances”, “Levels” and “Crossovers” again when making changes after the initial Dirac Live measurement.
If Bass Management or Bass Control™ is set as the Dirac Live filter option for the unit, the following restrictions apply.
The following settings under Speakers - Manual Setup in the Setup Menu cannot be changed.
Distances
Levels - Test Tone
Crossovers
Speaker Layout - Subwoofer Mode
Speaker Layout - Subwoofer Layout
Advanced - Low Frequency Effects
Advanced - 2ch Playback
Audio - Subwoofer Level Adjust in the Setup Menu cannot be changed.
Audio - IMAX Audio Settings in the Setup Menu is set to Auto and cannot be changed.
Dialog Enhancer and Tone can not be used in the Options Menu.
Only Distances, Levels and Crossovers can be applied in the following sound modes. Acoustic filters cannot be applied.
Multi Ch Stereo
Rock Arena
Jazz Club
Mono Movie
Video Game
Matrix
To use these restricted functions, turn off Dirac Live or select a filter where Dirac Live Room Correction is applied.