Search result
Connecting and playing back from a digital device (Coaxial/Optical)
Connect digital device to this unit. link
Press the input source select button (COAXIAL or OPTICAL 1/2) to switch the input source to “COAXIAL” or “OPTICAL 1/2”.
The digital audio signal that is being input is shown as follows in the display.
“COAX:PCM |
or |
“OPT1:PCM |
or |
“OPT2:PCM |
xxxxkHz” |
xxxxkHz” |
xxxxkHz” |
(xxxx is the sampling frequency.)
If the sampling frequency cannot be detected, “Unlocked” will be displayed.
“Unsupported” is displayed when audio signals that are not supported by this unit are input.
Audio signals that can be played back
See D/A converterlink.
NOTE
Do not input non-PCM signals, such as Dolby Digital, DTS and AAC. This causes noise and could damage the speakers.
If the sampling frequency switches, muting may operate for 1 – 2 seconds, cutting the sound.