Choose whether to connect the home network to a wireless LAN or a wired LAN.
When connecting to the network using wired LAN, select “Wired” after connecting a LAN cable.
When connecting to the network using wireless LAN, select “Wi-Fi” and configure the “Wi-Fi Setup”. link


Use the wireless LAN (Wi-Fi) function to connect to a network.


Use a LAN cable to connect to a network.

Wi-Fi Setup

Connect to a wireless LAN (Wi-Fi) router.
The router can be connected in the following ways. Select the connection method to suit your home environment.

“Wi-Fi Setup” is not displayed in the setting menu when “Connection” in the setting menu is set to “Wired”.


Select the network you wish to connect to from the list of possible networks shown on the display.

Select the network you wish to connect to from the list of wireless networks.

Select “Rescan” if the network cannot be found.

Enter your password and press ENTER.

Share Wi-Fi setting from an iOS device

Use your iOS device (iPhone/iPod/iPad) to connect to the network. By connecting your iOS device to this unit using Wi-Fi, the unit can be automatically connected to the same network as your device.

Select “Share Wi-Fi setting from an iOS device” on the display.
Check that your iOS device is connected to the wireless LAN (Wi-Fi) router and select “Denon CEOL” from “SET UP NEW AIRPLAY SPEAKER...” at the bottom of the Wi-Fi configuration screen of your iOS device.
Tap “Next” on the screen of the iOS device.

The iOS device firmware version needs to support iOS 7 or later.

WPS Router

Use a WPS-compatible router to connect using the push button method.

Select “WPS Router” on the display.
Switch to the WPS mode by pressing the WPS button of the router you wish to connect to.

The time for pressing the button varies depending on the router.

Press ENTER within 2 minutes.


Enter the name (SSID) and password of the network you wish to connect to.

Set the following items.


Input the name of the wireless network (SSID).


Select the encryption method according to the encryption setting of the access point you are using.


Input the password.

Select “Test Connection” at the end of the setting.

The wireless LAN (Wi-Fi) settings of this unit can also be configured from a PC or tablet that supports wireless LAN connection.

Touch and hold the Button Input Circle and BACK keys on the main unit for at least 3 seconds when the power of the unit is on.
Connect the wireless LAN of the PC or tablet used to “Denon CEOL” when the message “Connect your Wi-Fi device to Wi-Fi network called “Denon CEOL”” appears in the display.
Start up the browser and enter “” in the URL.
Use the browser to enter the settings, select “Save Settings” and then exit the settings.

Set “1” as the default key setting of the router when connecting to a WEP encrypted network. (The default key of this unit is fixed as “1”.)

back to top