2ch Playback

Select the method for setting the speakers used in the 2-channel direct and stereo playback modes.

Setting

Select the method for setting the speakers used in the 2-channel direct and stereo playback modes.

Auto
(Default):

The settings in “Speakers” are applied. link

Manual:

Set the speakers for 2-channel playback. Make the following settings:

Front

Set the size of the front speakers for 2-channel playback.

Large
(Default):

Use a large speaker that can adequately play back very low bass frequencies.

Small:

Use a small speaker that has inadequate playback capacity for very low bass frequencies.

When “Speaker Config.” - “Subwoofer” in the menu is set to “None”, “Large” is automatically set. link

Subwoofer

Set the presence of a subwoofer.

Yes
(Default):

Use a subwoofer.

No:

Select when a subwoofer is not connected.

When “Speaker Config.” - “Subwoofer” in the menu is set to “None”, No is automatically set. link
If the “Front” setting is “Small”, the setting is automatically “Yes”.

SW Mode

Select low range signals to be reproduced by subwoofer.

LFE
(Default):

When “2ch Playback” - “Front” is set to “Large”, only LFE signals are output from the subwoofer. Also, when “2ch Playback” - “Front” is set to “Small”, the front channel low range signals are added to the LFE signals and output from the subwoofer.

LFE+Main:

The front channel low range signal is added to the LFE signal output from the subwoofer.

This can be set when “2ch Playback” - “Subwoofer” is set to “Yes”.

Crossover

Set the maximum frequency of the bass signal output from each channel to the subwoofer.

40 Hz / 60 Hz / 80 Hz / 90 Hz / 100 Hz / 110 Hz / 120 Hz / 150 Hz / 180 Hz / 200 Hz / 250 Hz (Default: 80 Hz)

This can be set when “2ch Playback” - “Subwoofer” is set to “Yes”.

When “2ch Playback” - “Front” is set to “Large” and “SW Mode” is set to “LFE”, “Full Band” is displayed and this cannot be set.

Distance FL / Distance FR

Set distance from main listening position to speaker.

0.00 m – 18.00 m (Default : 3.60 m) /
0.0 ft – 60.0 ft (Default : 12.0 ft)

Set the difference in the distance between the speakers to less than 6.00 m (20.0 ft).

Level FL / Level FR

Adjust the level of each channel.

-12.0 dB – +12.0 dB (Default: 0.0 dB)

back to top