Connecting speakers

NOTE

Disconnect this unit’s power plug from the power outlet before connecting the speakers. Also, turn off the subwoofer.

Connect so that the speaker cable core wires do not protrude from the speaker terminal. The protection circuit may be activated if the core wires touch the rear panel or if the + and - sides touch each other. (Protection circuitlink)

Never touch the speaker terminals while the power cord is connected. Doing so could result in electric shock.

Use speakers with impedance of 4 - 16 Ω/ohms.

Connecting the speaker cables

Carefully check the left (L) and right (R) channels on the speakers being connected to this unit, and be sure to connect the polarities correctly.

Peel off about 10 mm of sheathing from the tip of the speaker cable, then either twist the core wire tightly or terminate it.
Conne spCable1 PMA50
Turn the speaker terminal counterclockwise to loosen it.
Conne spCable2 PMA50
Insert the speaker cable’s core wire to the hilt into the speaker terminal.
Conne spCable3 PMA50
Turn the speaker terminal clockwise to tighten it.
Conne spCable4 PMA50

back to top