Charging

Envaya can be charged and operated on battery power. It can also be operated from an AC power source by connecting it to the USB to AC power adapter (available commercially) using the supplied USB cable.
Please make sure you charge the battery completely before listening on battery power.

After purchase, charge this unit before use.

 

DSB50BT

DSB150BT

DSB250BT

Operating life *1 (hours)

10

11

13

Charging time *2 (hours)

2.5

3.0

3.5

The playback time may differ depending on the ambient temperature, playback volume, and usage conditions.

If using a USB to AC power adapter with an output of 2.1A or higher.

NOTE

Only use the supplied USB cable.

Rating of adapter should be DC 5 V, and between 2.1 A and 2.4 A.

Must be used with an approved adapter suitable for the countries where the requirement will be applied.

Charging the speaker

Open the cap on the rear side.
Connect the small end of USB cable to the speaker.
Connect the large end of the USB cable to a USB to AC power adapter and a power source.
NOTE

When connecting the dedicated charging cable to the charging port, be sure to match the cable connector with the shape of the socket. Forcing the connector into the socket will cause damage.

Remove the USB cable and firmly close the cap when charging is completed.

Charge DSB250BT

Battery indicator

The battery indicator uses 5 LEDs to indicate the status of the charge process when connected to the USB to AC power adapter.

LED_illust

When connected to the USB to AC power adapter (charging)

The battery indicator is always lit when charging.

The battery indicator turns off when charging is complete.

Charging status (Approximate)

Status Indicator

81 - 99 %

LED_99-81

61 - 80 %

LED_80-61

41 - 60 %

LED_60-41

21 - 40 %

LED_40-21

Less than 20 %

LED_20

When running on battery power

Press and release the Power Button button to check the remaining battery. The remaining battery level is displayed for approximately 2 seconds.

When the battery indicator flashes on battery power, connect Envaya to the USB to AC power adapter.

Remaining battery (Approximate)

Status Indicator

81 - 100 %

LED_100

61 - 80 %

LED_80

41 - 60 %

LED_60

21 - 40 %

LED_40

7 - 20 %

LED_20

Less than 7 %

LED_20

back to top