Connecting to a WPS network


Refer to Page

If your wireless router support WPS (Wi-Fi Protected Setup™) your HEOS wireless speaker can optionally connect to your network using the “Push Button” method by following these steps:

Wi-Fi Protected Setup™ is trademarks of Wi-Fi Alliance.

Press the WPS button on your router.
Within 2 minutes, press and hold the Connect button on the rear panel of the HEOS speaker for 3 seconds.
The LED on the front of the speaker will flash green for several seconds as it connects to your WPS router.
When the connection is complete, the LED on the front of the speaker will turn solid blue.

back to top