Connect and playback from a digital device (Coaxial/Optical)

Connect digital device to this unit. link
Press INPUT SELECT to switch the input source to “COAXIAL 1/2” or “OPTICAL 1/2”.

The digital audio signal that is being input is shown as follows in the display.

“COX1:PCM

or

“COX2:PCM

or

“OPT1:PCM

or

“OPT2:PCM

xxxxkHz”

xxxxkHz”

xxxxkHz”

xxxxkHz”

(xxxx is the sampling frequency.)

If the sampling frequency cannot be detected, “Unlocked” will be displayed.

“Unsupported” is displayed when audio signals that are not supported by this unit are input.

Files that can be played back

NOTE

Do not input non-PCM signals, such as Dolby Digital, and DTS. This causes noise and could damage the speakers.

If the sampling frequency switches, such as from A mode to B mode in a CS broadcast, muting may operate for 1 – 2 seconds, cutting the sound.

back to top