Search result
Playing CDs
This section uses playback from a CD as an example.
Press the input source select button (CD) to switch the input source to “CD”.
The “CD” input indicator lights.
Playback the CD.
Use VOLUME 
to adjust the volume.
to adjust the volume.Playback in source direct mode
The signal does not pass through the tone adjustment circuitry (BASS, TREBLE and BALANCE), resulting in playback of a higher sound quality.
Press SOURCE DIRECT on the main unit to turn on source direct mode.
The SOURCE DIRECT indicator lights.
Playback in ANALOG MODE
If analog mode is turned on when playing an analog input source (PHONO, CD, NETWORK, AUX, RECORDER), power to the digital input circuit and Bluetooth module is turned off. This enables you to enjoy audio playback with high sound quality without sound quality being affected by noise that occurs from the digital control circuit.
Press ANALOG MODE on the main unit to turn analog mode on.
ANALOG MODE indicator lights.
Analog mode switches on or off each time the button is pressed.
|
Analog mode on: |
The power of the digital input circuit and Bluetooth module is turned off. |
|
Analog mode off: |
Analog mode is not used. |
A digital input source (“COAXIAL”, “OPTICAL 1”, “OPTICAL 2”) or “BLUETOOTH” source cannot be selected when analog mode is on.
The input source automatically switches to “CD” if analog mode is turned on during playback of a digital input source (“COAXIAL”, “OPTICAL 1”, “OPTICAL 2”) or “BLUETOOTH” source.
When the analog mode is switched, the mute circuit is activated for about 5 seconds.