ALARM SETUP

Audio from the set input source can be played back at a specified time. Audio can also be played at the same time every day.

Use shirosankaku shirosankaku-Reverse White-Arrow-Left   White-Arrow-Right to change to desired setting, then press ENTER to enter the setting.
MODE SELECT

Use shirosankaku shirosankaku-Reverse to select the alarm mode, then press ENTER.

ONCE ALARM:

Playback starts and stops (the power turns off) once only at the set times.

EVERYDAY ALARM:

Playback starts and stops (the power turns off) at the set times each day.

SOURCE SELECT

Use shirosankaku shirosankaku-Reverse to select the source, then press ENTER.

DISC / TUNER / ANALOG IN / OPTICAL IN 1 / OPTICAL IN 2 / Bluetooth

If you have selected “TUNER” in “SOURCE SELECT”, select the Preset Number.

When no name has been registered for the selected preset number, the frequency appears after the preset number is displayed.

When “Bluetooth” is selected, this unit attempts to connect to the previously connected device.

The alarm may not work on some Bluetooth devices.

VOLUME SELECT

Use shirosankaku shirosankaku-Reverse to adjust the volume, then press ENTER.

ON TIME

Use shirosankaku shirosankaku-Reverse to select “hours” for the alarm start time, then press ENTER.

Use shirosankaku shirosankaku-Reverse to select “minutes” for the alarm start time, then press ENTER.

OFF TIME

Use shirosankaku shirosankaku-Reverse to select “hours” for the alarm stop time, then press ENTER.

Use shirosankaku shirosankaku-Reverse to select “minutes” for the alarm stop time, then press ENTER.

ALARM ON/OFF

Use White-Arrow-Left White-Arrow-Right to select “ON” or “OFF” for the alarm, then press ENTER.

The clock indicator lights and the alarm setting is entered.

The alarm settings are displayed for 3 seconds.

Press POWER Power Button to set the power to standby.

Alarm standby mode is set, and the power indicator lights orange.

back to top