This switches the headphone amplifier gain. Set this according to the connected headphones. It is recommended that you first listen using “NORM”, and then switch to “HIGH” if the volume is too low.


NORM (Default):	Set the gain of the headphone amplifier to “NORM”.
HIGH:	Set the gain of the headphone amplifier to “HIGH”.

NOTE

If the output mode selection switch (OUTPUT) is set to “FIXED”, the gain setting will be “NORM” even if the gain selection switch (GAIN) is “HIGH”.

The headphone volume varies depending on the gain setting. Decrease the volume the audio first if changing this setting while listening to audio.

Output mode selecting switch (OUTPUT)

Set the output mode according to the device to be connected.


FIXED:	This fixes the volume level output from the headphones jack. Set when connected to an external amplifier or active speaker.
VAR (Default):	The volume level output from the headphones jack can be adjusted. Set when listening using headphones.

NOTE

This setting is not enabled even when the output mode selection switch (OUTPUT) is switched when the power is turned on. Turn the unit’s power on and off again to enable this setting.

When “FIXED” is set, audio is output from the headphones jack, but the volume level is the maximum level and cannot be adjusted. When “FIXED” is set, do not connect headphones to this unit.

Charge mode selecting switch (CHARGE)

Switches the charge mode when the power is on.


ON (Default):	This unit charges when it is connected to a computer or USB charger. It charges when the power is on or off.
OFF:	To prevent noise caused by charging, this unit is not charged when the power is on, even if this unit is connected to a computer or USB charger. This unit is charged when the power is off, whether the status is CHARGE ON or CHARGE OFF.

Setting list