Listening to music via a digital connection (COAXIAL/OPTICAL-1/OPTICAL-2)

Press Button Input Circle to switch the input source to “COAXIAL”, “OPTICAL-1” or “OPTICAL-2”.

The digital audio signal that is being input is shown as follows in the display.

Display digital PMA60

(xxxx is the sampling frequency.)

If the sampling frequency cannot be detected, “Unlocked” will be displayed.

“Unsupported” is displayed when audio signals that are not supported by this unit are input.

Play back music on the connected device.

The speakers output music from the connected device.

Audio signals that can be played back

NOTE

Do not input non-PCM signals, such as Dolby Digital and DTS. This causes noise and could damage the speakers.

back to top