Tactile Transducer

Set the level and low pass filter cutoff frequency when using tactile transducers.

Tactile Transducer

Sets the tactile transducer option.

Enabled:

Enables tactile transducers.

Disabled
(Default):

Disables the tactile transducers.

For Tactile Transducer connections, use the Subwoofer 4 PRE OUT connector.

This can not be set when “Speaker Layout” - “Subwoofers” is set to “4 spkrs”.

Level

Adjusts the volume of the tactile transducer output.

–12.0 dB – +12.0 dB (Default : 0.0 dB)

The “Level” are reflected in all input sources.

If you wish to adjust the tactile transducer level for each input source, carry out the settings in “Tactile Transducer”.

Low Pass Filter

Selects the low pass filter cutoff frequency for the tactile transducer output.

40 Hz / 60 Hz / 80 Hz / 90 Hz / 100 Hz / 110 Hz / 120 Hz / 150 Hz / 180 Hz / 200 Hz / 250 Hz (Default: 80 Hz)

The “Low Pass Filter” are reflected in all input sources.

back to top