Layout

Configuraiton

Set the speaker layout when installing 1 set (2-channels) of Height, Ceiling or Dolby Atmos Enabled speakers.

The layouts that can be selected differ depending on the combinations of “Amp Assign” and floor speaker settings in the menu. (Amp Assignlink, Front/Center/Surround/Surround Backlink)

[2-channel heigh speakes]

Settings

AUDIO OUT connectors

Height Speakers

Layout

HEIGHT 1

HEIGHT 2

None

-

-

-

2 spkrs

Front Height

Front Height

-

Top Front

Top Front

-

Top Middle

Top Middle

-

Top Rear

Top Rear

-

Rear Height

Rear Height

-

Front Dolby

Front Dolby

-

Surround Dolby Flower Mark 1

Surround Dolby

-

Back Dolby Flower Mark 2

Back Dolby

-

This can be selected when using Surround speakers. Set “Surround” in the menu to “Yes”. link

This can be selected when “Assign Mode” is set to “11.1ch” or “9.1ch” and “Surround Back” is used in the menu. link

Connection

Select the output terminals for Height speakers.

Spkr + Pre-out
(Default):

Speaker and pre-out outputs are active.

Pre-out Only:

Pre-out outputs are active. Speaker outputs are disconnected for enhanced audio quality using only the pre-out terminals.

When “Amp Assign” is set to “Preamplifier”, the “Connection” setting of all speakers will be fixed as “Pre-out Only”.

back to top