Setting the preset channels and changing the received frequency on the main unit

Skip-Left /–, +/ Skip-Right on the main unit can be used both for switching the preset channel and for tuning.Before operating them, switch the main unit to the “PRESET MODE” or “TUNING MODE” using the procedure below.

Press SETUP.
Use shirosankaku shirosankaku-Reverse to select “TUNER SETUP”, then press ENTER.
Use shirosankaku shirosankaku-Reverse to select “MODE SELECT”, then press ENTER.
Use shirosankaku shirosankaku-Reverse to select “PRESET MODE” or “TUNING MODE”, then press ENTER.

PRESET MODE:

Press Skip-Left /–, +/ Skip-Right on the main unit to switch preset channels.

This is the same operation as CHANNEL –, + on the remote control unit.

TUNING MODE:

Press Skip-Left /–, +/ Skip-Right on the main unit to changethe received frequency.

This is the same operation as TUNE –, + on the remote control unit.

back to top