Search result
Advanced Setup
Set advanced settings relating to speakers.
Subwoofer Output
Subwoofer Output
Selects which low frequency signals are sent to the subwoofer outputs.
|
LFE |
The subwoofer outputs receive the LFE track, plus any redirected bass from speakers with crossovers set. Use this setting as the default for home theater bass management in a typical room. |
|
LFE+Main: |
The subwoofer outputs receive the LFE track, plus redirected bass, and a copy of the low frequency signals from all full band speakers. |
“Subwoofer Output” can be set when “Speaker Layout” - “Subwoofer” in the menu is set to “Yes”. link
Play music or a movie source and select the mode offering the strongest bass.
If “Crossovers” - “Front” and “Center” are set to “Full Band”, and “Subwoofer Output” is set to “LFE”, no sound may be output from the subwoofers, depending on the input signal or selected sound mode. link
Select “LFE+Main” if you want the bass signals to always be produced from the subwoofer.
Bass Extraction LPF
Set the low pass filter for the bass to be copied from the Full Band Speaker for each speaker when “Subwoofer Output” is “LFE+Main”.
|
40 Hz / 60 Hz / 80 Hz / 90 Hz / 100 Hz / 110 Hz / 120 Hz / 150 Hz / 180 Hz / 200 Hz / 250 Hz (Default : 80 Hz) |
Setting can only be performed for speakers for which “Crossovers” is set to “Full Band”.
LPF for LFE
Selects the crossover point for the LFE channel. Set this when you want to change the playback frequency (low pass filter point) of the subwoofer.
|
80 Hz / 90 Hz / 100 Hz / 110 Hz / 120 Hz/ 150 Hz / 180 Hz / |