Resetting the firmware to the default state

When the network function or this unit do not operate correctly, the problem may be solved by resetting the firmware to the default state.

It is confirmed that the network connection has no problem, but the unit cannot connect to the Internet.

The solution described in "Resetting your speaker" does not work. link

For such cases, perform the following operation:

Ope Restore DH250
Unplug the power cord from the power outlet.
Plug in the power cord while holding down the Bluetooth( Button Bluetooth ) button.
Release the button after the status LED starts to blink in orange.

When the status LED switches from blinking orange to solid, the recovery process is complete.

Since this process includes a firmware recovery, it takes some time to complete.

This process will clear out all the information that you set.

After performing this RESET to default state, an update to actual firmware version is needed.

Do not unplug the power cord until the entire process completes.

If the problem is not solved after performing this operation, contact our customer service center.

back to top