Setting the TV auto play function

Set this when playing audio from a TV on this unit. When the TV is turned on, this unit turns on and the input source is automatically switched to “OPTICAL 1”, “OPTICAL 2” or “COAXIAL” so that the audio from the TV can be played through this unit. Set this according to the connector on this unit where the TV is connected.

Ope TV Auto RC1249
Press TV AUTO-PLAY to select the setting.

The setting changes each time TV AUTO-PLAY is pressed.

OPTICAL 1 / OPTICAL 2 / COAXIAL / Off
(Default: OPTICAL 1)

When the analog mode is set to “ANALOG MODE 1” or “ANALOG MODE 2”, the TV auto play function does not work.link

Depending on your TV, the TV auto play function may not work.

This unit will not automatically turn off when the TV is turned off.

The TV auto play function works when an audio signal is input to this unit, but if the sampling frequency of the input audio signal is 88.2 kHz or more, the TV auto play function does not work. TVs normally output 48 kHz audio signals and the TV auto play function will work, but if you connect a device that outputs an audio signal of 88.2 kHz or more and try to use it, the TV auto play function may not work.

back to top