Setting the Remote ID

When using multiple Denon AV receivers in the same room, make this setting so that only the desired AV receiver operates.

The default setting is “ID-1”.

Press and hold RC SETUP for more than 3 seconds.

“SETUP” and LED_RC indicator flashes twice on the remote control unit.

Use shirosankaku shirosankaku-Reverse to display “RC-ID” on the remote control unit and press ENTER.
Use shirosankaku shirosankaku-Reverse to set the remote ID and press ENTER.

“OK” flashes four times on the remote control unit and the normal operation mode is restored.

Remote control unit display

Remote ID

ID-1

1

ID-2

2

ID-3

3

ID-4

4

NOTE

When you change the remote ID, make sure that the remote control unit and the remote ID of the main unit are exactly the same. link

back to top