Setting the display time length of the remote control unit display

Use the following procedure to set the length of time for which to display data such as zone and mode on the display panel of the remote control unit.

The default setting is “05SEC”.

Press and hold RC SETUP for more than 3 seconds.

“SETUP” and LED_RC indicator flashes twice on the remote control unit.

Use shirosankaku shirosankaku-Reverse to display “DISPL” on the remote control unit and press ENTER.
Use shirosankaku shirosankaku-Reverse to set the display time length and press ENTER.

“OK” flashes four times on the remote control unit and the normal operation mode is restored.

Remote control unit display

Display time


5 sec


10 sec


15 sec

back to top