Specifying the zone used with the remote control unit

When the ZONE SELECT button is pressed, only the set zone can be operated with the remote control unit.

The default setting is “M23”.

Press and hold RC SETUP for more than 3 seconds.

“SETUP” and LED_RC indicator flashes twice on the remote control unit.

Use shirosankaku shirosankaku-Reverse to display “ZLOCK” on the remote control unit and press ENTER.
Use shirosankaku shirosankaku-Reverse to set the zone to be used and press ENTER.

“OK” flashes four times on the remote control unit and the normal operation mode is restored.

Remote control unit display

Zone to be used

M

MAIN ZONE only

M2

MAIN ZONE / ZONE2

M23

MAIN ZONE / ZONE2 / ZONE3

back to top