Setting the display time length of the remote control unit display
Use the following procedure to set the length of time for which to display data such as zone and mode on the display panel of the remote control unit.
The default setting is “05SEC”.
Press and hold RC SETUP for more than 3 seconds.
“SETUP” and 
indicator flashes twice on the remote control unit.
Use 
to display “DISPL” on the remote control unit and press ENTER.
to display “DISPL” on the remote control unit and press ENTER.Use to set the display time length and press ENTER.
to set the display time length and press ENTER.“OK” flashes four times on the remote control unit and the normal operation mode is restored.
|
Remote control unit display |
Display time |
|---|---|
|
05SEC |
5 sec |
|
10SEC |
10 sec |
|
15SEC |
15 sec |