Specifying the zone used with the remote control unit
When the ZONE SELECT button is pressed, only the set zone can be operated with the remote control unit.
The default setting is “M23”.
Press and hold RC SETUP for more than 3 seconds.
“SETUP” and 
indicator flashes twice on the remote control unit.
Use 
to display “ZLOCK” on the remote control unit and press ENTER.
to display “ZLOCK” on the remote control unit and press ENTER.Use to set the zone to be used and press ENTER.
to set the zone to be used and press ENTER.“OK” flashes four times on the remote control unit and the normal operation mode is restored.
|
Remote control unit display |
Zone to be used |
|---|---|
|
M |
MAIN ZONE only |
|
M2 |
MAIN ZONE / ZONE2 |
|
M23 |
MAIN ZONE / ZONE2 / ZONE3 |