Overview

What you can do with this unit

Part names and functions

Connections

Connecting the power cords

Getting the HEOS App

Setting up first HEOS built-in device

Adding more HEOS built-in devices

Connecting devices

Pairing this unit to a HEOS built-in device

Unpairing this unit

Settings

Adjusting the subwoofer output level

Adjusting the low pass filter

Adjusting the phase

Adjusting the status light brightness

Tips

Troubleshooting

The power turns off and the status LED flashes in red

Connecting to a WPS network

Resetting factory settings

Resetting the firmware to the default state

Status LED

Status LED table

Appendix

Power management

Supported file types and codecs

Trademark information

Adjusting the low pass filter

Select “Low Pass Filter”.

Set the frequency cutoff point.


Optimized (recommended)	Select when using with HEOS built-in speakers. Optimized values are set to each of the speakers.
80Hz - 250Hz (for experts)	When using with other speakers, configure settings that match the characteristics of the combined speakers.