Overview

What you can do with this unit

Part names and functions

Connections

Connecting the power cords

Getting the HEOS App

Setting up first HEOS built-in device

Adding more HEOS built-in devices

Connecting devices

Pairing this unit to a HEOS built-in device

Unpairing this unit

Settings

Adjusting the subwoofer output level

Adjusting the low pass filter

Adjusting the phase

Adjusting the status light brightness

Tips

Troubleshooting

The power turns off and the status LED flashes in red

Connecting to a WPS network

Resetting factory settings

Resetting the firmware to the default state

Status LED

Status LED table

Appendix

Power management

Supported file types and codecs

Trademark information

The power turns off and the status LED flashes in red

The power turns off and the status LED flashes in red.

The protection circuit has been activated due to a rise in temperature within this unit. Unplug the power cord, wait about an hour until this unit cools down sufficiently, and then turn the power on again.