Overview

What you can do with this unit

Part names and functions

Connections

Connecting the power cords

Getting the HEOS App

Setting up first HEOS built-in device

Adding more HEOS built-in devices

Connecting devices

Pairing this unit to a HEOS built-in device

Unpairing this unit

Settings

Adjusting the subwoofer output level

Adjusting the low pass filter

Adjusting the phase

Adjusting the status light brightness

Tips

Troubleshooting

The power turns off and the status LED flashes in red

Connecting to a WPS network

Resetting factory settings

Resetting the firmware to the default state

Status LED

Status LED table

Appendix

Power management

Supported file types and codecs

Trademark information

Connecting to a WPS network

Connecting to a WPS network.

If your wireless router support WPS (Wi-Fi Protected Setup™) this unit can optionally connect to your network using the push button method by following these steps:

(Wi-Fi Protected Setup™ is trademarks of Wi-Fi Alliance.)

Press the WPS button on your router.

Within 2 minutes, press and hold the CONNECT button on the rear panel of this unit for 5 seconds.

The LED on the front of this unit will flash green for several seconds as it connects to your WPS router.

When the connection is complete, the LED on the front of this unit will turn solid blue.