Specifications
Audio section
|
Rated output: |
2-channel |
|
20 W+20 W (6 Ω/ohms, 1 kHz, T.H.D. 0.7 %) |
|
|
Maximum effective output power: |
25 W+25 W (6 Ω/ohms, 1 kHz, T.H.D. 10 %) |
|
Output connectors: |
Speaker: 6-16 Ω/ohms (impedance) |
|
Headphones: Φ3.5 mm jack |
|
|
Total harmonic distortion rate |
ANALOG IN: 0.1 % |
|
S/N ratio (10 W, 6 Ω/ohms, IHF-A): |
ANALOG IN: 83 dB |
|
Frequency response (1 W, 6 Ω/ohms): |
10 Hz-20 kHz (+0.5 dB, –3 dB) (SPEAKER OPTIMIZATION: OFF) |
USB section
|
Input data sampling frequency: |
44.1 kHz, 48 kHz |
|
Input data bit length: |
16 bit, 24 bit |
Bluetooth section
|
Communication system: |
Bluetooth version 3.0 |
|
Transmission power: |
Maximum 2.5 mW (Class2) |
|
Maximum communication range: |
Approx. 10 m in line of sight * |
|
Frequency band: |
2.4 GHz band |
|
Modulation method: |
FHSS (Frequency-Hopping Spread Spectrum) |
|
Supported profiles: |
A2DP 1.3/AVRCP 1.5 |
|
Supported codecs: |
aptX Low Latency/AAC/SBC |
The actual communication range varies depending on the influence of such factors as obstructions between devices, electromagnetic waves from microwave ovens, static electricity, cordless phones, reception sensitivity, antenna performance, operating system, application software etc.
General
|
Power supply: |
AC230 V, 50/60 Hz |
|
Power consumption: |
15 W |
|
Power consumption in standby mode: |
0.3 W |
Speaker section
|
Type: |
Full range/1 speaker, passive radiator type |
|
Speaker impedance: |
6 Ω/ohms |
|
Max. permissible input: |
25 W (IEC), 50 W (PEAK) |
|
Average output sound pressure level: |
82 dB (1 W/1 m) |
|
Speaker unit: |
Full range (65 mm cone type x1), passive radiator type (85 mm x1) |
|
Cable length: |
1.5 m |
For purposes of improvement, specifications and design are subject to change without notice.