Power does not turn on / Power is turned off

Power is not turned on.

Check whether the power plug is correctly inserted into the power outlet. link

This unit is in standby mode. Press the Power Button button on the unit or the AMP POWER Power Button button on the remote control. link

Power automatically turns off.

The sleep timer is set. Turn on the power again. link

“Auto-Standby” is set. “Auto-Standby” is triggered when there is no operation for a set amount of time. To disable “Auto-Standby”, set “Auto-Standby” on the menu to “Off”. link

The power turns off and the protection circuit indicator shows one long blink and two short blinks in red.

Stop playback on the playback device, and then turn the power off and on again.

If the problem is not solved by turning the power off and on again, this unit’s amplifier circuit has failed. Unplug the power cord and contact our customer service center.

The power turns off and the protection circuit indicator shows one long blink and three short blinks in red.

This unit’s power circuit has failed. Unplug the power cord and contact our customer service center.

The power turns off and the protection circuit indicator shows one long blink and four short blinks in red.

The protection circuit has been activated due to a rise in temperature within this unit. Turn the power off, wait about an hour until this unit cools down sufficiently, and then turn the power on again.

Please re-install this unit in a place having good ventilation.

Stop playback on the playback device, and then turn the power off and on again.

The power turns off and the protection circuit indicator shows one long blink and five short blinks in red.

Check the speaker connections. The protection circuit may have been activated because speaker cable core wires came in contact with each other or a core wire was disconnected from the connector and came in contact with the rear panel of this unit. After unplugging the power cord, take corrective action such as firmly re-twisting the core wire or taking care of the connector, and then reconnect the wire. link

Stop playback on the playback device, and then turn the power off and on again.

If the problem is not solved by turning the power off and on again, this unit’s amplifier circuit or power circuit has failed. Unplug the power cord and contact our customer service center.

back to top