Overview

Accessories
Part names and functions

Front panel
Side panel
Rear panel
Placing

Wall or floor stand mounting
Powering your speaker
Getting the HEOS app

Setup

Setting up the HEOS app for the first time with a HEOS Built-in device
Adding the registration of HEOS Built-in devices in the HEOS app

Adding wired HEOS Built-in devices
Adding wireless HEOS Built-in devices
HEOS account

Playback

Playing from streaming music services

Selecting a room/device
Selecting the music track or station from music sources
Listening to the same music in multiple rooms

Grouping rooms
Ungrouping rooms
Grouping all rooms
Ungrouping all rooms
Listening to Internet Radio
Playing music stored on your mobile device
Playing back files stored on a PC or NAS
Playing music from the AUX input
Playing music from a USB flash drive
Playing music from a Bluetooth device
AirPlay function

Playing songs from your iPhone, iPod touch, iPad or Mac
Playing songs from Windows PC
Play a song from your iPhone, iPod touch, iPad or Mac on multiple synced devices (AirPlay 2)
Spotify Connect function

Playing Spotify music with your speaker
Quick Select function
Operating this unit by voice with the Siri function
Stereo pairing

Troubleshooting

Troubleshooting

Cannot connect the speaker to the network
Cannot pair a Bluetooth mobile device with the speaker
Cannot hear Bluetooth music
Music cuts out or delays sometimes
I hear a delay when using the AUX input with my TV
Connecting to a network using an iOS device
I hear distortion when using the AUX input
Resetting network settings
Resetting your speaker
Buttons do not operate correctly
Cleaning of the fabric around the speaker

Status LED

Status LED table

Appendix

Power management
Enable/disable Wi-Fi and Bluetooth functions
Supported file types and codecs
Trademark information
Specifications
PDF Download

Connecting to a network using an iOS device

This speaker supports Apple’s WAC (Wireless Accessory Configuration) setup mode. WAC setup mode allows you to connect your speaker to your network without requiring you to type in the network name and password.
The iOS device firmware version needs to support iOS 10.0.2 or later.

Press and hold - and Triangle Right Pause buttons for 3 seconds.
On your iOS device, go to the Wi-Fi menu under Settings.
Select “Denon Home 400” under “SET UP NEW DEVICE...” at the bottom of the list.
Follow the instructions on the screen to complete setup.

HEOS system will stay in WAC setup mode for 15 minutes. If the device is not setup within 15 minutes, it will revert back to its previous network connection. Press the Triangle Right Pause button if you want to cancel WAC setup mode.

NOTE

During setup, you will be prompted to either scan the Apple HomeKit QR code or enter the setting code (8-digit number) that are affixed to the speaker or the included Quick Start Guide. However, if the network module is replaced at a service center, these codes will become invalid. You can use the HEOS app to connect this speaker to the network. link

back to top